![]() Hold the EM-Tec VS8 holder in the palm of your hand and block both rods.To shorten the spring, the holder needs to be disassembled and assembled: To reduce the spring force, the springs can be shortened this will also allow for thicker samples. ![]() The EM-Tec VS8 mini spring-loaded vise has been designed to hold thin samples in the fully closed position there is approx. The sample can be off center in this holder. The tension on the 2 springs will hold the sample between the moving and the fixed jaw. Place the sample between the vise jaws and gently release the moving vise jaw. To open the EM-Tec VS8 mini spring-loaded vise clamp, pull the moving vise jaw against the springs. Available with either the standard 3.2Ømm pin or an M4 threaded hole for mounting on the SEM sample stage.Ĭonsider wearing gloves to avoid contamination. ![]() The maximum clamping capacity between the vise jaws is 8mm. The EM-Tec VS8 spring-loaded vise clamp consists of a vise base of Ø25mm x12mm H, a moving vise jaw and two rods with springs to close the jaw. EM-Tec VS8 mini spring-loaded SEM sample vise
0 Comments
Leave a Reply. |